When inserting or initializing a pluggable hardware module – such as a Pluggable LTE module (P-LTE-GB) on a Cisco ISR 1100 series router (e.g., C1127-8PLTEP) – the subslot may initialize in an administratively disabled state, leaving its cellular interface completely missing from the interface table. While the console log suggests a remediation command, differences across Cisco IOS XE command parsers cause that exact command to fail with an incomplete syntax error.
This guide explains how to resolve the % Incomplete command. error when running no hw-module subslot and restore power to a disabled subslot.
Following an Online Insertion and Removal (OIR) event or module detection in subslot 0/2, the cellular interface does not appear in show ip interface brief, and hardware queries against the module (such as show cellular 0/2/0 hardware) fail to parse.
Checking the console logs or running show platform reveals that the chassis physically detects the Pluggable LTE card in subslot 0/2, but the slot itself is in an admin down state:
%SPA_OIR-6-OFFLINECARD: Card (subslot 0/2) offline in subslot 0/2
Subslot 0/2 is administratively shutdown; Use 'no hw-module subslot 0/2 shutdown' to enable
Entering global configuration mode and running the exact string printed in the syslog message results in a CLI parser rejection:
Router# configure terminal
Router(config)# no hw-module shutdown
^
% Invalid input detected at '^' marker.
Router(config)# no hw-module subslot 0/2 shutdown
% Incomplete command.
On Cisco ISR 1000 / 1100 platforms running IOS XE, the hw-module CLI hierarchy requires a trailing power-state keyword after shutdown to specify how power is controlled for the subslot.
Appending a question mark (?) after shutdown reveals the required trailing keyword (unpowered). Enter global configuration mode and run the full command to negate the unpowered shutdown state:
Router# configure terminal
Router(config)# no hw-module subslot 0/2 shutdown unpowered
As soon as the command is accepted, the router applies power to the subslot and logs an OIR event bringing the card online:
%SPA_OIR-6-ONLINECARD: SPA (P-LTE-GB) online in subslot 0/2
If you are working on a different Cisco chassis or IOS XE train where unpowered is not the expected argument, use inline help (no hw-module subslot 0/2 shutdown ?) or try one of these platform-specific variations:
Router(config)# no hw-module subslot 0/2 shutdown powered
Router(config)# no hw-module subslot 0/2 default
Router(config)# no hw-module shutdown subslot 0/2
Once the card initializes online, exit configuration mode, save the running configuration so the subslot remains powered after a reboot, and verify that the cellular interface is now visible:
Router(config)# end
Router# write memory
Router# show platform
Router# show ip interface brief
The subslot status under show platform will now display as ok, active, and the corresponding cellular interface (e.g., Cellular0/2/0) will appear in show ip interface brief ready for configuration.
Cisco console warnings often omit the trailing power-state parameter required by modern IOS XE hardware parsers. Keep these three points in mind when troubleshooting missing modules or disabled subslots:
See the following Cisco links that have been used to construct this article:
For more useful article please visit our knowledgebase.